Sun-microsystems SG-XPCIE1FC-EM8-Z Uživatelský manuál stáhnout pdf (Strana 39)

Chapter 2 Hardware Installation and Removal 13

9. Replace the computer case and tighten the case screws.

The HBA is now installed in the computer and is ready for media attachment.

▼ To Connect the Optical Cable

Note – The HBA does not allow normal data transmission on an optical link unless

it is connected to another similar or compatible Fibre Channel product (that is,

multimode to multimode).

Use multimode fiber-optic cable, intended for short-wave lasers, that adheres to the

specifications in

TABLE 2-1.

1. Connect the fiber-optic cable to an LC connector on the HBA (see

FIGURE 2-4).

TABLE 2-1 Optical Cable Specifications

Fiber-Optic Cable Maximum Length Minimum Length Connector

OM3 - Multimode 50/125 micron

fiber (2000 MHz*km bandwidth

cable)

2.125 Gb/s: 0.5m - 500m

4.25 Gb/s: 0.5m - 380m

8.5 Gb/s 0.5m – 150m

.5 meters LC

OM2 - Multimode 50/125 micron

fiber (500 MHz*km bandwidth cable)

2.125 Gb/s: 0.5m – 300m

4.25 Gb/s: 0.5m – 150m

8.5 Gb/s 0.5m – 50m

.5 meters LC

OM1 - Multimode 62.5/125 micron

fiber (200 MHz*km bandwidth cable)

2.125 Gb/s: 0.5m – 150m

4.25 Gb/s: 0.5m – 70m

8.5 Gb/s 0.5m – 21m

.5 meters LC

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 55 56

Žádné komentáře

Sun-microsystems SG-XPCIE1FC-EM8-Z Uživatelský manuál Strana 39